High Gloss sealer provides a high-gloss, wet-look protective barrier that prolongs the life of any paver project. Use this product to protect and beautify a paver’s appearance.
BENEFITS
High-gloss, wet-look finish
Minimizes salt and freeze/thaw damage
Provides UV protection
Stabilizes joint sand from washout, weeds & ants
Color enhancing
APPLICATIONS
Concrete Pavers
*This product is sold by the carton (four - 1 gallon cans per carton) OR 5 gallon bucket*
INSTRUCTIONS
CLEAN
Wait 28 days after installing polymeric sand before sealing.
Thoroughly sweep surface of joint sand or loose material.
Spot clean if needed with one of these SRW cleaning products:
CDX = Cleaner & Degreaser X-treme for oil and grease spots
RE = Rust Eliminator for rust and mineral removal
Prepare all pavers with one of these SRW cleaning products:
EF = for Efflorescence removal
PW = Paver Wash for general cleaning & polyhaze removal.
CLIMATE
After cleaning, wait at least 24 hours before sealing. Surface and joints must be completely dry.
Recommended application temperatures are 50°F-80°F (10°C-27°) from installation through the cure process.
Do not apply if inclement weather is forecasted within 24 hours
APPLY
STIR THOROUGHLY
Apply with an SRW Products approved Slit Foam Roller and sprayer.
Spray then back roll. This prevents an uneven finish. A 2-person application is recommended.
Always spray against a wet edge and do not overlap a previously sealed and dried area.
Start at the highest project eleveation
Do not allow sealer to pool on pavers or in joints.
Repeat if desired.
CURE
Allow sealed area to dry and cure 24 hours.
Protect area from water and rain until dry.
Dry-tack free: 25 minutes
Foot traffic: 24 hours
Vehicle traffic: 72 hours
Note all calculations based on 68°F-77°F (20°C-25°C)
